Turning On The 2Big Network - LaCie 2big Network User Manual

LaCie 2big Network
User Manual

2.1. Turning On the 2big Network

The power supply kit is composed of two cables: one cable (A) con-
nects to the LaCie drive; and the other cable (B) connects to a power
outlet, such as a wall outlet or a surge protector
1. Connect Cable A to the 2big Network.
2. Connect Cable B to the power supply brick (C).
3. Connect Cable B to a surge protector or wall outlet.
4. Turn on the drive by moving the power switch on the back of the
drive to the "on" position.
The 2big Network may take up to 60 seconds to boot up.
CAUTION: Only use the AC adapter supplied with your specific La-
Cie device. Do not use a power supply from another LaCie device or
another manufacturer. Using any other power cable or power supply
may cause damage to the device and void your warranty.
Always remove the AC adapter before transporting your LaCie drive.
Failure to remove the adapter may result in damage to your drive
and will void your warranty.
TECHNICAL NOTE: You may use your LaCie drive when in a for-
eign country thanks to its 100-240 Volt power supply. To be able to
use this feature, you may need to purchase an appropriate adapter
or cord. LaCie accepts no responsibility for any damage to the drive
resulting from the use of an inappropriate adapter. Using an adapter
other than one authorized by LaCie will void your warranty.
(Fig. 04).
Setting Up Your LaCie 2big Network
safe 100 big
off auto on
page 12
Fig. 04