Training Wheels - Huffy Coaster Brake Bicycles Owner's Manual

Training Wheels

Attach the legs to the bicycle frame:
- Put the alignment insert [1], a leg [2], and a nut [3] on
each end of the rear wheel axle [4]
- Make sure the tab of the alignment insert [5], is
to the rear of the axle and in the slot [6] of
the frame
- Make sure both training wheels are the same
distance from the ground
- Tighten the nuts securely.
Operation
WARNING:
Before each ride, make sure both nuts are tight. Also make sure both training
wheels are the same distance from the ground.
As your child's ability and balance improve, you may raise or remove the training wheels.
- To move the training wheels, loosen the nut, slide the leg to the correct position, and retighten the
nut.
- To remove the training wheels, remove the nut, leg, and alignment insert.
Quick Release Operation
- To release the clamp force on the component, move the Quick Release (QR) lever counterclockwise to
the open position.
- To apply the clamp force on the component, move the QR lever clockwise to the closed position.
- To adjust the clamp force of the QR, loosen or tighten the nut on the threaded end.
- You must use strong force to move the quick release lever to the "close" position. If you can easily
move the lever to the "close" position, the clamping force is too light.
- If the clamping force of the quick release mechanism is too light, the component can loosen while
riding. This can cause injury to the rider or to others.
WARNING! OPERATE THE QUICK RELEASE LEVER BY HAND ONLY. DO NOT USE A HAMMER
OR ANY OTHER TOOL TO TIGHTEN THE QUICK RELEASE LEVER.
WARNING! DO NOT TIGHTEN THE QUICK RELEASE MECHANISM BY TURNING THE LEVER IN
A CIRCULAR MOTION. THIS CAUSES THE CLAMPING FORCE TO BE TOO TIGHT.