Pan And Tilt Adjustment; Accessory Installation; Barndoor; Colour Frame - Philips Selecon Operation Manual

WING WHITE LED WALL WASHER Operation Manual

Pan and Tilt Adjustment

Adjusting the pan angle
Release the set screw above the joint
(as shown) and adjust accordingly. Re-
lock after adjustment.

Accessory Installation

Barndoor

To install the barndoor, first hook it in to the slots on the front face and swing the barndoor up. Secure the barndoor
with the two hex screws in the barndoor. Tighten these using a 3mm allen key until they are secure. DO NOT
OVERTIGHTEN as this causes undue stresses in the parts.

Colour Frame

The colour frame slots in between the barndoor and the front of the Wing
LED luminaire. Note: the barndoor accessory is required if you wish to use a
colour frame in the Wing LED as the barndoor creates the slot to hold the
colour frame.
Version 1: June 2011 ©2011 Philips Selecon All Rights Reserved
8of13
Adjusting the tilt angle
The tilt can be adjusted by unlocking the
hex screw located as shown. Re-lock
after adjustment.
Secure barndoor here.
DO NOT OVERTIGHTEN.