Table of Contents
Advertisement
Cleaning water
inlet strainers
Release the water pressure
in the supply hose
6. Push up the closing cap (1st) and place the drain
hose back in its holder (2nd).
7. Carefully remove the pump cap.
A little more residual water will flow out.
8. Remove foreign objects/fluff from inside and clean
the interior. The pump impeller wheel must be able
to rotate.
Clean any residual lye or fluff from the thread of
the pump cap and pump housing.
9. Insert the pump cover and screw tight.
10.Insert and close the service flap.
To avoid unused detergent from flowing into the drain
during the next wash cycle:
11.Pour approx. 1 litre / 1 ¾ pt of water into
chamber II.
12.Select the Drain programme.
This is necessary if very little or no water flows into the
washing machine.
1. Turn off the water tap.
2. Turn the programme selector to any programme
(except Spin and Drain).
3. Press the Start button, and allow the programme
to run for approx. 40 seconds.
4. Turn the programme selector to Off.
33
Hide quick links:
Advertisement
Table of Contents
