Other Functions; Fading In And Fading Out; Falling Asleep To Music; Sleep Timer - Sony MDS-JE480 Operating Instructions Manual

Other Functions

Fading in and fading out

Fade-in Recording gradually increases the
signal level at the start of recording. Fade-out
Recording gradually decreases the signal level
at the end of recording.
Fade-in Recording
During recording pause, press FADER on
the remote.
"b" flashes in the display and the deck
performs Fade-in Recording for five seconds
(factory setting) until the counter reaches
"0.0s."
Fade-out Recording
During recording, press FADER on the
remote.
"B" flashes in the display and the deck
performs Fade-out Recording for five seconds
(factory setting) until the counter reaches
"0.0s," then pauses.
Tip
Do the following procedure to specify the fade-in or
fade-out duration for recording.
1 While the deck is stopped or playing, or
paused, press MENU/NO.
2 Turn AMS (or press ./> repeatedly)
until "Setup?" appears, then press PUSH
ENTER or YES.
3 Turn AMS (or press ./> repeatedly)
to select the setting, then press PUSH
ENTER or YES.
To change the
duration of
Fade-in Recording
Fade-out Recording
4 Turn AMS (or press ./> repeatedly)
to select the duration, then press PUSH
ENTER or YES.
Both the Fade-in and Fade-out durations can be
set in 0.1 second steps.
5 Press MENU/NO.
25
GB
Select
F.in
F.out

Falling asleep to music

— Sleep Timer

You can set the deck so that it turns off
automatically after a specified duration.
1
While the deck is stopped or playing,
press MENU/NO.
2
Turn AMS (or press ./>
repeatedly) until "Setup?" appears,
then press PUSH ENTER or YES.
3
Turn AMS (or press ./>
repeatedly) until "Sleep Off" appears in
the display, then press PUSH ENTER or
YES.
4
Turn AMS (or press ./>
repeatedly) to select the setting, then
press PUSH ENTER or YES.
To
Turn on Sleep Timer Sleep On
Turn off Sleep Timer Sleep Off (factory setting)
1) The deck turns off automatically after 60
minutes.
5
Press MENU/NO.
Tip
You can check the remaining time.
Once you turn on Sleep Timer, the remaining time is
displayed when you select "Sleep" in Setup Menu.
Select
1)