Undoing The Last Edit; Undo - Sony MDS-JE480 Operating Instructions Manual

Changing the recorded level after
recording (continued)
To cancel the operation
Press MENU/NO or x in steps 1 to 6. If you
press PUSH ENTER or YES in step 7 and
recording starts, you cannot interrupt the
operation.
Notes
• Do not disconnect the AC power cord or move the
deck while recording is in progress. This may
damage the recording data preventing recording
from being performed properly.
• You cannot change the recorded level of a track
recorded in LP2 or LP4 Stereo mode.
• Do not use an MD that is damaged or dirty. This
may prevent recording data from being recorded
properly.
• Changing the recording level repeatedly results in
poor sound quality.
• The recording level will not return to the exact
original level once the recording level has been
changed even if it returned to the original level.
• The recording level cannot be changed while the
timer is activated.
• You cannot undo any S.F edit operation with the
Undo Function.
24
GB

Undoing the last edit

— UNDO

You can undo the last edit operation and restore
the contents of the MD to the condition that
existed before the operation. Note, however,
you cannot undo an edit operation if you
perform any of the following operations after
the edit:
• Start recording.
• Press MUSIC SYNC on the remote.
• Change the recorded level after recording (S.F
Edit).
• Turn off the deck or eject the MD.
• Disconnect the AC power cord.
1
While the deck is stopped, playing, or
paused, press MENU/NO.
"Edit Menu" appears in the display.
2
Turn AMS (or press ./>
repeatedly) until "Undo?" appears.
"Undo?" does not appear if no editing has
been done.
3
Press PUSH ENTER or YES.
One of the messages appears depending on
the last edit operation.
4
Press PUSH ENTER or YES.
"Complete!" appears.