Marking Track Numbers While Recording - Sony MDS-JE480 Operating Instructions Manual

Recording tips (continued)
Marking track numbers while
recording
— Manual/Automatic Track Marking
You can mark track numbers either manually or
automatically while recording. By marking
track numbers at specific points, you can easily
locate the points later or edit the MD.
Marking track numbers manually
(Manual Track Marking)
While recording, press REC z at the point
where you want to add a track number.
Marking track numbers automatically
(Automatic Track Marking)
When recording from a CD player or MD deck
connected to a DIGITAL IN connector, the deck
marks track numbers in the same sequence as
the source. When recording from other sources
connected to the DIGITAL IN connector or a
source connected to the ANALOG IN jacks, do
the procedure below to mark track numbers
automatically. However, you cannot mark track
numbers automatically if the sound of the
source to be recorded is noisy (e.g., tapes or
radio programs).
1
While the deck is stopped, press MENU/
NO.
2
Turn AMS (or press ./>
repeatedly) until "Setup?" appears,
then press PUSH ENTER or YES.
3
Turn AMS (or press ./>
repeatedly) until "T.Mark LSyn"
appears, then press PUSH ENTER or
YES.
4
Turn AMS (or press ./>
repeatedly) to select the setting, then
press PUSH ENTER or YES.
To
Turn on Automatic
Track Marking
Turn off Automatic
Track Marking
10
GB
Select
T.Mark LSyn (factory
setting)
T.Mark Off
5
Press MENU/NO.
When you set Automatic Track Marking to
on, "L.SYNC" lights up.
The deck marks a track number whenever
the input signal level drops to –50 dB
trigger level for Automatic Track Marking)
or below for at least 1.5 seconds.
1) Factory setting.
To change the trigger level for
Automatic Track Marking
Do the procedure below to change the signal
level that triggers Automatic Track Marking.
1
While the deck is stopped, press MENU/
NO.
2
Turn AMS (or press ./>
repeatedly) until "Setup?" appears,
then press PUSH ENTER or YES.
3
Turn AMS (or press ./>
repeatedly) until "LS(T)" appears, then
press PUSH ENTER or YES.
4
Turn AMS (or press ./>
repeatedly) to select the level, then
press PUSH ENTER or YES.
You can set the level at any value between
–72 dB and 0 dB, in 2 dB increments
(–50 dB is the factory setting).
5
Press MENU/NO.
Tips for automatic track marking
• When recording from a CD player or an MD deck
connected to the DIGITAL IN connector, the entire
material might be recorded as a single track in the
following cases:
— When you consecutively record the same track
two or more times using single-track repeat play.
— When you consecutively record two or more
tracks with the same track number but from
different CDs or MDs.
— When you record tracks from certain CD or
multi-disc players.
1)
(the