Programming; Cooking Timer - Bosch Cooking Hob Operating Instructions Manual

Programming a
burner to turn off
automatically

Cooking timer

When the programmed time
has elapsed
Changing the programmed
time
Cancelling the programme
Notes
14
Enter a certain time for the required burner. When the
programmed time has elapsed, the burner will go out
automatically.
The burner must be alight.
1. Touch the 0 symbol once. The display will show the
following image: ‹‹
2. Touch the 0 symbol a second time. The display will
briefly show your hob set-up
symbol to select the required burner.
3. Having selected the required burner, touch the - or +
symbols in the following 5 seconds to programme the
required time.
This sequence may be used to programme any burner on
your hob. YOU MAY ONLY HAVE 2 BURNERS
PROGRAMMED AT A TIME.
The programme will start after a few seconds or when you
select another burner.
The display will always show the time remaining for the
first programme to finish.
When the programmed time has elapsed, the burner
goes out, a beep sounds for 30 seconds, ‹‹
on the right of the display and on the left the dots
around.
Touch any symbol and the beep stops and the display
goes out.
TURN THE CONTROL KNOB TO THE 0 SETTING FOR
THE BURNERS THAT HAVE BEEN SWITCHED OFF BY
THE TIMER.
Touch the 0 symbol, select the burner and change the
time using the - or + symbols in the following 5 seconds.
The new time programmed will begin after a few seconds.
Touch the 0 symbol, select the burner and change the
time to ‹‹ using the - or + symbols.
Ú
The indicator disappears after a few seconds or will show
the time remaining in the following programme.
The timer function does not continue after a power failure.
It can programme a duration of up to 99 minutes.
If you want to check the programmed times, you can view
all the programmes by touching the 0 symbol.
V
.
. Then touch the 0
Ú Ú ‹‹
Ú
Ú Ú
is shown
Ú
move