How To Replace The Battery - Husky fex21 User Manual

How to replace the battery

CAUTION: Before removing the old battery pack, check that the fex21 pen is
not slotted into the unit. Attempting to remove the battery pack while a pen is
fitted may cause damage to both battery pack and pen.
•
Switch off the unit.
•
Pull the two small catches forward until they click open. Remove the old
battery pack, using a small coin as a lever if necessary.
•
Fit a new battery pack into your fex21by locating the two small lugs in the
side of the computer unit and pressing the battery pack firmly in place until
the two small catches click into position.
How to replace Alkaline batteries
•
Switch off the unit and remove the battery pack by pulling forward the two
small catches and levering the pack out, using a small coin if necessary.
•
Remove the four AA-size Alkaline cells from the pack.
•
Insert four new cells, checking that the polarity is correct.
•
Replace the battery pack.
NOTE: Alkaline batteries are not recommended for use with peripheral loads or
some PCCards, and are not suited to low temperature operation.
CAUTION!
•
Keep batteries out of children's reach.
•
Replace batteries with the same or equivalent type as recommended.
•
Dispose of or recycle used batteries in accordance with the manufacturer's
recommendations and local customs.
•
Take care to replace batteries correctly; there is a danger of explosion if
batteries are replaced incorrectly.
•
Battery chemical leakage is corrosive. In the unlikely event of battery
leakage, DO NOT TOUCH. In case of accidental contact, wash immediately
with running water.
Contents