Binatone SYMPHONY 2610 System User Manual page 60

Switch off power at the mains socket, wait for a few
seconds and then switch back on. This may solve the
problem.
"I cannot make The handset's keypad may be locked (see page
a call." Unlock it before you make a call.
Only one handset (or the base unit) can be connected
to the outside line at once. If another handset is already
using the line, you need to wait until it's finished its call.
Call block may have been set and turned on (see
page 53).
"When I press Make sure the batteries are fitted in your handset. If
keys, nothing the Battery Level symbol on the display shows 'low',
happens." recharge the batteries.
"When I key in a Try moving the handset closer to the base unit.
number, it
Try a different position for the base unit — somewhere
appears on the
higher if possible, or further from other electrical
display, but I
equipment.
can't make an
outside call."
Call block may have been set and turned on (see
page 53).
"The phone Check that the base unit's mains power adapter is
does not ring" plugged in and power is switched on. The base unit
needs mains power for normal operation of the phone
— not just for charging the batteries.
Make sure you're using the telephone line cable that
was supplied with your Symphony 2610. Other
telephone line cables might not work.
Check that the total REN value of all equipment con-
nected to your telephone line is no more than 4 (see
page 2). Disconnect one or more telephones and see
whether that helps.
Binatone Help Line: 0845 345 9677
Troubleshooting
10).
57
(Local Call rate)