Optional Color Enhancement Light - RCA PRO846 User Manual

Optional Color Enhancement Light

An optional VLP04 color enhancement light shown on page 55 helps create
brighter, sharper pictures in very low light conditions. It lights subjects in
darkened areas or corrects unflattering shadows.
Light Power Button
1. Attach the rechargeable battery or
AC adapter/charger to power the
camcorder.
2. Make sure the camcorder is turned
off. Then attach the light to the light
power connector and accessory shoe
as shown above.
3. Press and hold the small button on the
CAM/OFF/VCR switch while placing
it in CAM.
4. Turn on the light by pressing the power
button on the light.
Note: Press the button again to turn off the
light.
5. To remove the light from the
camcorder, depress the light and
release the tab from the accessory
shoe. Then slide the light off the
camcorder.
44
Light Power Connector
Tab
Accessory Shoe
Notes: Turn on the light only when needed.
The power consumption of the light is much
more than that of the camcorder. When the
light is turned on, the operation time of the
rechargeable battery is reduced by more than
half.
Avoid bumping or shaking the light when in
use. The light's bulb is sensitive when hot
and may burn out.
Do not allow water to drop on the light when
in operation.
Do not touch the bulb with your fingers. It
may shorten its service life.
Make sure the front case of the light is
properly attached after removing it or
replacing a bulb.
Caution: Do not
touch the light power
connector when the
camcorder is on.