Alpine Blackbird PMD-B200P Owner's Manual page 4

KEEP FINGERS AWAY WHILE THE MOTORISED FRONT PANEL
OR MOVING MONITOR IS IN MOTION.
Failure to do so may result in per-
sonal injury or damage to the product.
Temperature
Be sure the temperature inside the vehicle is between +45°C
(+113°F) and 0°C (+32°F) before turning your unit on.
Fuse Replacement
When replacing the fuse(s), the replacement must be of the same
amperage as shown on the fuse holder. If the fuse(s) blow(s)
more than once, carefully check all electrical connections for short
circuiting. Also have your vehicle's voltage regulator checked.
Servicing the Unit
If you have problems, do not attempt to repair the unit yourself.
Return it to your ALPINE dealer or the nearest ALPINE Service
Station for servicing.
4
Installation Location
Make sure the PMD-B200P will not be exposed to:
• Direct sun and heat
• High humidity
Characteristics of LCD Panel
• After turning the system off, a slight ghost of the image will
remain temporarily. This is an effect peculiar to LCD technology
and is normal.
• Under cold temperature conditions, the screen may lose contrast
temporarily. After a short warmup period, it will return to normal.
• The LCD panel is manufactured using an extremely high precision
manufacturing technology. Its effective pixel ratio is over 99.99%.
This means that 0.01% of the pixels could be either always ON or
OFF.
Using Headphones
If ACC or the monitor's power source is turned off, a loud noise may
be produced through the headphone jack. Be sure to remove the
headphones from your ears before you turn the monitor off.
• Excessive dust
• Excessive vibrations