Assembly - Husqvarna ST 121E Operator's Manual

Setup
LOOSE PARTS
Use the chart below to verify that all parts have been
shipped.
Description
Carriage bolts
Shoulder Bolt
Flange nuts
Washer
Knob
Cap Plunger
Chute
Deflector
Installing the Handle
1. Remove temporary cable ties holding cables at handle
adjustment holes (Figure 2).
2. Release handle adjustment levers on both sides.
1
2
1. Cable ties
2. Adjustment lever
3. Lift operator handle up to the desired height, and close
adjustment lever ensuring the positioning pin on the
lower handle engages one of the three holes on the
upper handle (Figure 3).
2
1
1. Positioning pin
2. Upper handle adjustment hole
Qty.
4
1
4
1
1
1
1
1
Figure 2
Figure 3

ASSEMBLY

4. Pull up and push down slightly on the handle to verify
handle is locked into place (Figure 4).
NOTE: If handle feels unsecure with the adjustment
levers closed, tighten adjustment handle nuts until the
handle feels secure.
5. Remove the cardboard from recoil start handle and
feed the recoil rope through the rope guide.
6. Snap two rotator cables and one wiring harness into
the three cable clips (Figure 5).
1
2
1. Handle
2. Recoil handle
3. Rope guide
4. Adjustment lever nut
1. Rotator cable
2. Wiring harness
3. Cable clip
5
3
4
Figure 4
1
3
Figure 5
2