Before Using Your Easyclean Snackmaker; Toasting Sandwiches - Sunbeam EasyClean Snack-For-Two GR6200 Instruction/Recipe Booklet

Before using your EasyClean
Snack Maker
Before using your EasyClean Snack Maker for
the first time, the non-stick cooking plates
must be seasoned. Turn the power ON and
pre-heat your EasyClean Snack Maker until
the Ready Light illuminates.
Wipe a small amount of butter onto the
plates, rub lightly and wipe away any excess.
NOTE: When using your Sunbeam Easy Clean
Snack Maker for the first time you may notice
a fine smoke haze being emitted from the
unit. This is normal. It is due to the initial
heating of internal components.

Toasting Sandwiches

1.Always pre-heat your EasyClean Snack
Maker until the Ready Light Illuminates
before use.
2.Always butter the outside of the bread. The
sandwich filling will be placed between the
unbuttered sides of the bread.
3.Place the buttered side of the bread
onto the cooking plate, then spoon the
recommended quantity of filling onto the
bread.
4.Place the top slice of bread on top of
the filling with the buttered side facing
upwards.
5.Gently close the lid until the two handles
close together. Click the latch into position
to keep the Snack Maker securely closed
during toasting. DO NOT FORCE THE LID
CLOSED (if the lid is difficult to close you
may have too much filling, or your bread
slices may be too thick).
1.Insert the plug into 230 or 240 volt
outlet.
2.Turn the power ON and preheat your
EasyClean Snack Maker until the Ready
light illuminates.
Note: Ensure that the cord is kept well away
from the cooking plates when in use.
6.Allow the sandwiches to toast for
approximately 3 minutes, depending on
the bread, filling and personal taste. Your
Snack Maker toasts both sides of bread at
the same time and seals in the filling.
7.The cooking plates are coated with a
durable non-stick coating. Some fillings
such as cheese, may melt and cause the
sandwich to stick to the cook plates. To
free the sandwich use a plastic spatula or
wooden spoon. Never use a sharp object
or metal as this will damage the non-stick
surface.
Note: The warm up and Ready lights are
thermostatically controlled and will cycle
during cooking to ensure that the correct
temperature is maintained.
™
3