Mitsubishi Electric MR-EX655W-N-A Operating Instructions Manual page 7

Bottom front of refrigerator
3
Adjustment and anchoring
(To prevent vibration, noise, movement, and doors left ajar)
Turn and lower the adjustable supports until they touch the fl oor and
the front casters are raised from the fl oor to fi x the refrigerator.
Preventing doors
from being left ajar
Adjust the supports to Adjust the adjustable supports as shown
make the refrigerator in the fi gures below.
level.
If the front of the
refrigerator is slightly
raised, the doors are
easier to close.
If the door is still tilted after adjustment of the supports
When installing the refrigerator in
the corner of a room, one of the
rear supports may sink, causing the
refrigerator to tilt. If this happens,
use a caster support or strong board
for adjustment. (Normally, use a
board with a thickness of 2 to 3 mm.)
Do not damage the refrigerant
circuit (pipes) or drive screws into it.
Although fl ammable refrigerant is used, the refrigerant circuit
is hermetically sealed and normally leaks will not occur.
Warning
Should the refrigerant circuit be damaged:
1. Do not use fl ames or electrical appliances nearby.
2. Open the windows to fully ventilate the room.
Then, contact the retail store where you purchased the
refrigerator.
Caster
Adjustable
support
Adjusting a tilted door or unevenness
The right door tilts down The left door tilts down
Right
Left
Rotate and lower the Rotate and lower the
right side left side
Turn the adjustable
supports in the arrow
direction until they
touch the fl oor.
Caution
If the supports are not
adjusted properly,
the refrigerator may
move and cause
injury.
4
If the installation
location is not level
or the supports sink
after a few days
of installation due
Adjustable
to the weight of
support
the food, the doors
may appear tilted.
Readjust the
supports.
* More than 100
kg of food can
be stored in the
refrigerator.
Rear support
Caster support
or strong board
Prepare for earthquakes
(for areas prone to earthquakes)
Pass 2 strong belts through the hand-holds on the top
rear of therefrigerator and anchor them to a strong
location, such as wall or post.
Warning
The refrigerator may tip over
and cause injury.
Adjustable support cover
Adjustable
support cover
The adjustable support cover
is stored inside the refrigerator
compartment at shipment.
Installing the adjustable
support cover
Fully insert the adjustable support
cover horizontally until it touches the
rear side.
cover
Adjustable Caster
support
The operation noise gets
louder immediately after
installation.
Immediately after instillation, when:
the weather is hot, the doors are
frequently opened or closed, or
any similar situation; the operation
noise will get louder because the
refrigerator will switch to high-speed
operation to cool with high power.
Strong belts
7