Replacing The Rear I/O Module - Lenovo C2 Series Hardware Maintenance Manual

Step 14. Holding the sides of the microprocessor with your fingers, position the microprocessor so that the
notches on the microprocessor are aligned with the tabs in the microprocessor socket.
Important: To avoid damaging the microprocessor contacts, keep the microprocessor completely level
while installing it into the socket.
Step 15. Lower the microprocessor straight down into its socket on the motherboard.
Step 16. To secure the microprocessor in the socket, close the microprocessor retainer and lock it into
position with the small handle.
Step 17. Use a thermal grease syringe to place 5 drops of grease on the top of the microprocessor. Each
drop of grease should be 0.03ml (3 tick marks on the grease syringe).
Step 18. Reattach the heatsink, the EMI cover, the computer cover, the speaker cover, the hard disk drive
cover and the optical disk drive.

Replacing the rear I/O module

Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
.
Chapter 8 Replacing hardware
49