Replacing The Keyboard And Mouse - Lenovo C2 Series Hardware Maintenance Manual

Step 8. Install the new hard disk drive as follows:
a. Slide the new hard disk drive into the drive bay.
b. Screw the 4 screws back onto the drive bay.
Step 9. Slide the hard disk drive bay back into position.
Step 10. Secure the hard disk drive bay to the chassis with the screw.
Step 11. Reattach the hard disk drive cover and secure it with the screw.

Replacing the keyboard and mouse

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches
or other damage.
To replace the keyboard and mouse
Step 1. Remove any media (disks, CDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right view"
and "Rear view" for help with locating the various connectors.
Note: Your keyboard will be connected to a USB connector on one side or at the rear of the
computer.
Step 4. Disconnect the defective keyboard cable from the computer and connect the new keyboard cable
to the same connector.
.
Chapter 8 Replacing hardware
33