Hunter Ceiling fan Owner's Manual And Installation Manual page 14

8 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Installing the Glass Bowl
8-8. First install B10 candelabra bulbs (60 Watt Maximum) into the
sockets.
8-9. If the fandangle is attached to the extra pull chain, remove it now.
8-10. Attach the extra pull chain (included) to the fan pull chain using
the plastic breakaway connector. (You may find the plastic
breakaway connector on the end of the extra chain.)
8-11. Thread the fan pull chain through the hole in the metal disc. Then,
thread the fan pull chain through the hole in the center of the glass
bowl.
8-12. Thread the light pull chain through the hole in the center of the
glass bowl. Then, Thread the light pull chain through the hole in
the center of the cover plate.
8-13. Thread the fan pull chain through the grommet hole in the side of
the cover plate.
8-14. Place the cover plate up against the
glass bowl. Align the holes in the cover
plate and glass bowl.
8-15. Thread the light pull chain through
the finial and screw the finial onto the
threaded rod end until tight.
8-16. Reattach the fandangle to the extra pull
chain.
Note: In compliance with US federal energy
regulations, this ceiling fan contains
a device that restricts the light kit to
a maximum of 190 Watts. Exceeding
that limit or the marked limit on this
product may result in fire hazard or
improper operation.
14
42790-01 • 20080925 • Hunter Fan Company
Breakaway
Connector
Light Bulb
Socket
(B10
Candelabra-
Based 60 Watt
Maximum)
Metal Disc
Threaded Rod
Glass Bowl
Cover Plate
Finial