Broil Feature; Resetting The Oven Temperature Control; Oven Rack Positions - Whirlpool RJE-3000 User Manual

Loosen the locking
screw: NOTICE position
of notches.
Lower: move black part
toward "LO."
One notch equals about
10 F (S'C).
Higher: move black
part toward "HI."
One notch equals about
PO'F (5-C).
To remove rack. pull
forward until rack
stops, lift and pull.
Variable Broil Feature:
You might want to broil some foods slower than others. Broiling
can be slowed down by setting a lower temperature on the Oven Temper-
ature Control Knob instead of "BROIL." Using a lower temperature will
cause the broil element to turn on and off during the broiling so that the
food broils more slowly
When the Oven Temperature Control Knob is on "BROIL," the
Broil Element heats all the time. Set the temperature lower and it heats
some of the time. The lower the temperature setting, the shorter are the
periods of heating
NOTE: The Oven Selector must be on BROIL and the door
must be partly open for all broiling temperatures.
Resetting the Oven Temperature Control:
Does your new oven seem hotter or colder than your old oven?
The temperatures in older ovens often shift very gradually, getting hotter
or colder without the user really noticing the change. Your new oven is
properly adjusted to provide accurate temperatures, but when compared
to your old range, the new design may give you different baking results. If
you think that the temperature setting on your range needs to be hotter or
colder. you can adjust the Oven Temperature Control Knob by yourself.
To adjust the setting. first pull the Oven Temperature Control Knob
straight off. On the back. just across from the locking screw. are a row of
notches on the black part of the knob and one tooth on the chrome part.
To set your oven about lO"F(5"C)
cooler,
loosen the locking screw
about two full turns and move the row of notches
one notch
closer to
"LO." To set your oven about lO"F(5"C)
warmer,
move the row of
notches
one notch
closer to "HI." Each notch equals about lO"F(5"C).
Tighten the locking screw and put the knob back on the control
panel.
Oven rack positions
Your oven has one rack. A second one may be purchased from
your dealer, if you wish. Always put the rack where you want it to be
before you turn on the wen.
To remove the rack. take hold of it on the front edge and pull it out
until it stops. Then lift up the front edge and pull again. It will slide past the
stops, out of the guides and out of the oven.
To put it back, fit the back corners into the guides at each side of
the oven and slide it in,
keeping the front tilted up until the rack passes
the stops in the rack guides.
~--
For: Place Rack:
Baking On the second rack guide from the bot-
tom or so
food
is in the center of the
oven.
Broiling
So food is about the distance from the broil
element suggested in the broiling timetable
under "Using the Oven Controls."
~I_~
Roasting LARGE On the bottom rack guides.
cuts of meat
Roasting
SMALLER
cuts of meat
-
So food is in the center of the oven.