Echo CS-370 Instruction Manual page 16

Echo chain saw

Hide thumbs Also See for CS-370:

Table of Contents

DESCRIPTION

5. Mount guide bar on studs (E) and slide toward sprocket (F) to

make saw chain installation easier. Install saw chain around

sprocket and guide bar as shown, with cutters on top of guide

bar facing forward.

6. Install sprocket guard over guide bar studs. Ensure chain

tension adjuster pin (H) fits into the guide bar adjuster hole (G),

brake band (J) is positioned around clutch drum. Tighten

sprocket guard nuts finger tight.

7. Turn saw over, and check brake band (J) for correct position on

clutch drum. If brake band is not in place around drum, remove

sprocket guard, and reinstall. Tighten sprocket guard nuts

finger tight.

8. Adjust saw chain tension, as instructed in "Adjustment, Chain

Tension".

Improper sprocket guard assembly can result in serious

injury, and will cause severe saw damage if unit is started. Never start or operate saw if brake band

is not in place on clutch drum. Always check chain brake operation after replacing guard. Do not use

saw if chain brake does not function properly.

Adjusting Chain Tension

Always loosen sprocket guard nuts before turning the chain tension

adjuster, otherwise the sprocket guard and tensioner will be

damaged.

1. Remove air cleaner cover and disconnect spark plug lead.

2. Loosen sprocket guard nuts.

For more information

scan this QR code.

Unlock chain brake

CS-370

X7503251406

Table of Contents