Peripheral Device Installation - Gigabyte 5SG100 User Manual

Hardware Installation
power saving function . This mainboard uses the existing power LED as
ACPI LED . If the ACPI LED is blinking, the system is in green mode. The
GN switch will force the system into green mode .

3.12. PERIPHERAL DEVICE INSTALLATION

After installation of the device and setup of the jumpers, the mainboard can
be mounted into the case and fixed by screw. To complete the mainboard
installation, the peripheral devices could be installed now. The basic system
needs a display interface card and a storage device.
If a PCI - Bus device is to be installed in the system, any one of four PCI -
Bus slots can be used for Slave or Master PCI - Bus device.
After installing the peripheral device, the user should check everything again
and prepare to power-on the system.
3-8