Table of Contents
Advertisement
Quick Installation Procedure
6
2. Quick Installation Procedure
2.1 Installing your AXIS 9010
Follow the instructions below to quickly install the AXIS 9010 on an Ethernet
network, which must be a TCP/IP-based system.
The AXIS 9010 supports DHCP server management and client IP address
management. By default, the IP address of the AXIS 9010, as well as the IP
addresses for the Bluetooth clients, are set automatically. No configuration is
therefore necessary and you can follow the instructions below.
If you do not have a DHCP server, IP address for the AXIS 9010 must be assigned
manually. Please go through the instructions 1-2 below and then refer to the
installation instructions in section 5. AXIS 9010 IP Setting, on page 15.
1. Connect your AXIS 9010 - first to the network with an Ethernet cable and then
to the mains supply with the power supply (AXIS type PS-B):
2. Check the following after about 30 seconds:
• The Power indicator displays a steady green light.
• The Network indicator displays a steady or a flashing orange or green light.
Your AXIS 9010 is now ready for use.
2.
Power Cable
1.
Network Cable
Advertisement
Table of Contents
