Table of Contents
Advertisement
Appendix E
Installation
Installation on Lexmark Optra and 4039
IMPORTANT
Note
Note
AXIS AFP IOP User's Manual
First, check the contents of your AFP IOP delivery, according to the
checklist in Section General.
1. Try to take antistatic precautions. If a wriststrap is not available, then
touch something grounded (a radiator or a PC cabinet) before handling
the PCB board.
2. Switch OFF the Lexmark Printer, and remove the Power Cord.
3. Open the top cover and open the right side cover.
4. For 4039 printers only:
Press the two blue metal pips on the lower part of the metal cover, and
pull out to loosen the cover. Push up the metal cover, push the cover
to the left and pull down gently. The Lexmark main board is now visi-
ble.
5. For all 4039 printers EXCEPT model 16L and 16L Plus:
Attach the DC/DC converter to the system board by plugging it into
the 5 pole connector at the top right corner of the Lexmark main
board. It is recommended to do this before installing the AFP IOP
Appendix E: Installation
77
Advertisement
Table of Contents
