Motorola D1001 User Manual page 7

the other end into the mains power wall socket and switch
the power on.
Connecting the handset and charger (Multi-
pack only)
If you have purchased a multiple pack, this process will need
to be carried out for all handsets and chargers:
1. Plug the mains power cable with the red connector into
the socket marked
2. Insert the 2 x AAA NiMH batteries supplied into the
handset. Then slide the compartment cover into place.
Getting started
on the underside of the charger.
3. Place the handset on the charger to charge for at least
24 hours. When the handset is fully charged the
icon will indicate that it is fully charged.
4. When the handset is fully charged after 24 hours, plug
the telephone line cord from the large base into the
telephone wall socket.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery
cells (2 x AAA Ni-MH 550mA rechargeable batteries)
supplied with your D1000. Please do not use alkaline or non
rechargeable batteries. It may cause permanent damage to
the product and void the warranty.
BATTERY LOW WARNING
If the icon flashes in the display, you will need to
recharge the handset before you can use it again.
During charging, the icon will scroll in the display.
Once fully charged scrolling will stop.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up to
10 hours talk time or up to 150 hours standby* time on a
single charge.
*All talk and standby times are approximate and depend on
features selected and usage pattern.
7