Advertisement
C heck that all the items on the delivery note have been supplied, before you assemble
Please report any shortages immediately. We have less sympathy with
your system.
a claim that goods were not supplied after the hire has ended, than we have for a
shortage reported at the beginning.
In particular, note the number of tie clip microphones and their associated clips.
Both can remain attached to costumes, and just vanish at the end of the show!
Connect receivers to mixer inputs and attach all aerials.
Single kits have their aerials attached, and these need only to be extended and set as
shown in the cover picture.
Multi-channel kits are supplied with 2 Dipole aerials that are connected to the ADA
(Aerial Distribution Amplifier) and this supplies RF signals to all receivers. Dipole
aerials should be a minimum of 3 metres apart. Set with the elements vertical. Note
that on UHF aerials there is a moulded 'E'. This is to show which element should be
at the bottom. VHF aerials have a whip for the upper element, and a helical for the
lower.
Failure to set aerials correctly can affect performance markedly. It is worth
Failure to set aerials correctly can affect performance in a marked manner. It is
spending time experimenting with aerial location, for a small change can often
worth spending time experimenting with aerial location, for a small change can
transform system performance.
often transform system performance.
Where we have supplied a flightcased system, you should note that we number the
transmitter, it's receiver and output cable with corresponding channel numbers.
Power up using either plugtop power supplies (single kits) or connect to the mains
and switch on the ADA (Aerial Distribution Amplifier) which in turn powers all the
receivers in the flightcase.
Connect the Microphone to each Pocket Pack transmitter in use.
Always test multichannel systems with all transmitters switched on.
Receivers lock onto the strong signals of their matching transmitters. In the abscence
of such a signal they will accept unwanted interference (known as intermodulation
interference - often shortened to 'intermod' ), which can light several segments of the
RF display. There is usually little or no audio present, but it can be confusing if
displays light on channels you weren't expecting!
Operation
Example of a flightcased kit.
Transmitters are supplied in their own case.
Bottom unit is an ADA, which allows all receivers
to share a pair of Dipole aerials. It also powers
itself and all receivers.
Advertisement
