Graco Swing N’ Bounce Instructions Manual page 8

GB
Instructions
Vibration Assembly and Seat Wire
See images -
1 3
Attaching Tray
Squeeze recline handle on seat and lower
4
seat before attaching tray.
Line up tray on edge of seat and insert peg
5
into hole and close tray.
See image
6
See image
7
Attaching Bouncer Legs
See images -
8 13
Attaching Seat Pad
See images -
14 16
Attaching Rear Legs
See image
17
- Insert rear legs into holes in housings as shown.
18 19
Button MUST snap through hole.
Attaching Front Legs
See image
20
The double buttons must fit into the channels inside
21
the battery housing.
Button MUST snap through hole.
Swing the leg outward until the single button snaps
22
its notch. CHECK that the leg is properly attached
by twisting it in the housing.
Repeat step 13 with other housing and leg.
23
Button MUST snap through hole.
Swing the leg outward until the single button snaps
24
its notch. CHECK that the leg is properly attached
by twisting it in the housing.
Front Tube
See images -
25 27
Attaching Front Tube to Legs
See image
28
Rear Tube
See image
29
CHECK that all tubes are securely attached.
30
CHECK that the parts of the frame are assembled
in the positions shown.
Hanger Tubes
See images -
31 32
Assembling Toy Bar
See images -
33 34
Attaching Carrier
See images -
35 36
Adjust Recline (3 positions)
See images -
37 39
To Secure Child
See images -
40 44
Use slide adjuster at shoulder and waist for further
45
adjustment. Repeat on other side.
46 When changing harness strap slots, MAKE SURE
harness straps are going through same slots in seat
pad.
The harness straps must go into the slot that is
47
even with or slightly above the shoulders.
Avoid twisting straps.
Installing Batteries
With baby out of swing, open the battery
48
compartment lid by inserting a screwdriver into
the coin slot. Insert three "D"-LR20 (1.5V) cell
batteries.
CHECK that the batteries are put in correctly.
49
Your swing will not run if the batteries are put
in backwards.
14
Starting Product
WARNING: avoid serious injury from falling or sliding
out. Always use harness. After fastening buckles, adjust
belts to get a snug fit around your child.
TO TURN PRODUCT ON:Press On /Off button or
press any speed from 1 to 6. When pressing On/Off
button, it automatically starts with the last speed setting
that was selected before the product was turned off.
Observe the swinging motion for a minute. It takes
time for the product to adjust to a setting. Change
setting if needed.
A small, quiet baby will swing higher on each setting
than a larger, more active baby.
Your seat may be stopped at any time the motor is
running without damaging the motor. Push product to
restart.
If your product motor stops operating by itself, a
protective device may have been activated. Turn off
motor, wait three minutes, then restart swing.
TO TURN PRODUCT OFF: Press On /Off button.
Button Functions
50
SPEED – Press On /Off button or press any speed
51
from 1 to 6. When pressing On/Off button, it
automatically starts with the last speed setting that
was selected before the swing was turned off.
ON/OFF POWER - Press to turn ON and turn
52
OFF. Press button to stop swing motion.
MUSIC - Push "Music" button to turn on music.
53
Push button again to advance to next track. There
are 10 songs.
MUSIC/NATURE OFF - Press button to turn OFF.
54
VOLUME— Press the plus (+) to raise the volume
55
and the minus (-) to lower the volume. There are
5 volume settings.
NATURE SOUNDS— Push "Nature" button to
56
turn on nature sound selection. Each press will
change to the next nature sound. After the 5th
sound is selected, it will return to the first track.
57 TIMER— Push "Timer" button to set the timer for
the swing and/or Music/Nature sounds. If the timer
button is not pushed, the swing and/or music/
nature sound will continue to play until the power
on/off button is pushed or the music/nature off
button is pushed.
When using the timer with the product on, if the
button is pushed once, the red speed light will
flash once and timer is set for 10 minutes. Pushing
the timer button a second time will increase the
run time to 20 minutes and the red speed light
will flash twice.
Pushing a third time will increase the time to 30
minutes and the red speed light will flash three
times.
When using the timer with the Music/Nature
sounds on, the timer will set to 10, 20 or 30
minutes as described for the swing, but there
will be no flashing light.
Head Support
See images -
58 59
Only use this head support on this swing.
59
Never use this head support on any other product.
Mix 'N Move
See images -
60 62
For Storage
See images -
63 64
Push buttons to fold.
63
Vibration
See images -
65 66
15