Care And Cleaning - Electrolux EWS 85210 A User Manual

The appliance does not drain the wa-
ter.
Change a function
You can change only some functions be-
fore they operate.
1. Press the Start/Pause button.
2. Change the function set.
Set the delay start
1. Press the delay start button again and
again until to set the correct delay.
2. Press the start/pause button, the appli-
ance starts the countdown of the delay
start. The related indicator flashes while
the start/pause indicator is off.
When the countdown is completed, the
programme starts automatically and
the indicator of the Start/pause comes
on.
You can cancel or change the set of
the delay start also when the appliance
starts the countdown.
Cancel the delay start
Press the delay start button again and
again until all the indicators are off.
The programme starts and the indicator of
the start/pause button comes on.
Open the door
While a programme operates, the appliance
door is locked.
To open the appliance door:
1. Press the Start/Pause button to stop
the programme.
2. Wait for some minutes before to open
the appliance door.
3. Close the appliance door and press
again the Start/Pause button. The pro-
gramme continues.
If the temperature and level of the wa-
ter in the drum are too high, you can-
not open the door.

CARE AND CLEANING

Warning!
Disconnect the appliance from the mains
supply before you clean it.
To open the door do the steps that fol-
low:
1. Turn the programme knob to
deactivate the appliance.
2. Wait for some minutes.
3. Make sure that no water is in the
drum.
Caution! If you deactivate the
appliance, it is necessary to set the
programme again.
At the end of the programme
• The appliance stops automatically.
• The indicator of the Start/Pause button
flashes.
• Turn the programme knob to
tivate the appliance.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
The washing programme is completed,
but there is water in the drum:
– The Rinse Hold option or a programme
that stops with water in the drum is set.
– The door stays locked.
– You must drain the water to open the
door.
To drain the water:
1. If the spin speed option is available, you
can decrease the spin speed.
2. Press the Start/Pause button. The ap-
pliance drain the water and spin.
3. When the programme is completed:
– The indicator of the Start/Pause but-
ton flashes or the End indicator is on.
– You can open the door.
4. Turn the programme knob to
activate the appliance.
External cleaning
Clean the appliance only with soap and
warm water. Fully dry all the surfaces.
Caution! Do not use alcohol, solvents
or chemical products.
electrolux 11
to
to deac-
to de-