Table of Contents
Advertisement
Fill with salt as follows:
1. Open the cap (A) of the salt dispenser.
2. Fill the dispenser with water (B)
3. Fill with 1 kg of special salt (C). As a result, approx.
1 litre of water will be displaced.
4. Remove salt from around the opening of the dis−
penser.
5. Close the salt dispenser by turning the cap until the
stop is reached.
6. Immediately run the "Pre−rinse"program to
wash away any salt residues.
The salt display will go out after 1 or 2 rinse cycles.
Do not remove the water feed valve, and do not
fill with detergent for any reason.
Setting the Water Softener
The dishwasher is equipped with a water softener de−
signed to remove minerals and salts from the water
supply, which would have a detrimental or adverse ef−
fect on the operation of the appliance.
The higher the content of these salts, the harder your
water is.
The softener should be adjusted according to the hard−
ness of the water in your area. Your local Water author−
ity can advise you on the hardness of the water in your
area.
Adjust the dosage as follows:
Turn the setting button using a coin or a screwdriver
until the arrow on the knob points to the desired num−
ber.
The arrow must point to a number and the po−
sition must be engaged positively.
Clarke
French degrees
(°TH)
degrees
0 − 9
0 − 12,5
9 − 18
12,5 − 25
18 − 26
25 − 37,5
26 − 35
37,5 − 50
> 35
> 50
The first wash cycle
− When using for the first time, use the Intensive pro−
gram.
PPM (Parts
Level
per Million)
0 − 125
1
125 − 250
2
250 − 375
3
375 − 500
4
> 500
5
A
4
3
5
2
1
B
C
9
Hide quick links:
Advertisement
Table of Contents
