Assembly Instructions For The Side Rail Assembly Kit - AEG ÖKO−FAVORIT 55750 Instructions For Use Manual

Assembly Instructions for the Side Rail Assembly
Kit
Components:
1 off Side rail, right
1 off Side rail, left
4 off Spacer 4 mm
4 off Spacer 3mm
4 off Spax screw 4.0 x 20 galvanised
A+B
550
Procedure:
Frame side panel thickness 19 mm:
− Remove the protective tape of the two spacing washers (DS 1) mounted on the side rails (SL R + SL L).
− Position the side rail (SL L):
− Press on and fix the side rail (SL L), and secure with the supplied screws (2x SCHR
− Repeat this procedure for side rail SL R.
Frame side panel thickness 16 mm:
− Remove the protective tape of the two spacing washers (DS 1) mounted on the side rails (SL R + SL L).
− Stick the separately−supplied 3 mm spacing washers (SL R + SL L) over the pre−mounted 4 mm spacing washers
(DS 1) as shown in Detail B.
The adhesive tape of the 3mm spacing washer (DS 2) must be on the outer side.
− Continue as described for the 19 mm thick frame side panel.
600
510min.
562−
568
762
16−
19
SL L
> Lower side (open) lying on the floor of the niche
> Edge lying against the side panel of the frame (see Detail A).
Detail A
neighbouring
SL R
edge
SL L
DS 1
DS 2
SCHR
Detail B
DS 1
DS 2
16
546
SL R
570
SL L
SCHR
19
574
759
153 0771 03 / 03.98
SL L
100
19
21
759
29