Cleaning And Care - Electrolux EBC GL6(S) Operating Insructions

Cleaning and care

While cleaning oven shelf runners, lamp glass and oven door, heating elements must not be switched on.
The oven has to be cooled down so as to be able to touch the central panels safely. Only the oven light must be switched on.
NEVER use high-pressure water cleaner for the oven!
Clean the appliance thoroughly and frequently! Avoid repeated burning of residue.
Cleanemail oven
- Do not use fine steel wool, scratching and scrubbing cleaning agents!
- You can use commercially available oven spray. Observe the manufacturer's instructions
-> Wash the inside of the oven with warm detergent lye or vinegar cleaner and a sponge/cloth
TIP: Clean chrome parts in the oven with moistened steel ball (available from major distributors); no steel wool!
- Always keep the door seal, door seal surface and the inside clean. Lack of appliance cleanliness can lead to hazardous situations.
Oven cover with catalytic cleaning aid
Control panel + oven door
Outside surfaces chromium steel smoothed:
- no aggressive/acidic or glass-ceramics cleaning agent
- no steel wool / pot cleaner
Cleaning movements
TIP: Clean with a soft, clean, moist micro-fibre cloth!
- Hinge brackets must always bear firmly on the hinges from the door to the oven!
- Clean inside panel with hot detergent lye
- Soak heavy contamination
- Keep rubber seals clean and do not damage!
Glass interior has a heat-reflective protective layer -
Do not scratch with a knife, scraper or scotch brite etc!
Remove slide rails
Unscrew knurled nut
TIP: Clean griddle guides with brush in a hot detergent lye or with steel ball
Clean accessory
Clean with hot detergent lye
(not suitable for dishwashers)
at temperatures over 200° C small contaminations and grease marks are deoxidised free of odour and fat.
- do not use scratching or scouring cleaning agents, oven sprays/steel wool
-> these damage the catalytic cleaning aid
- Only open the oven for a short time -> this supports the catalytic cleaning aid
- do not use textile cloths, the shedding gets caught on the rough surfaces!
No rotating movements
when cleaning, as surfaces
will be damaged!
Pull oven shelf gently
over the set screw
(raised porous surface)
Reinstall:
Insert behind and reinsert
over the set screw.
Screw tightly with knurled nut.
Pull out to the front
Alulook outside surfaces:
- If necessary a commercially available
chromium steel cleaner can be used
-> Observe manufacturer's instructions
in using these cleaning agents!
Wash with a soft brush in hot detergent
lye or in the dishwasher
TIP: In cases of stubborn residue use
a stainless steel ball
(only on chromium panels!)
5
P a g e