Installing The Dishwasher - AEG FAVORIT 50660 User Information

Installing the dishwasher

• The dishwasher must be installed on a firm floor and adjusted to en-
sure that it is stable and level in all directions.
• To compensate for unevenness in
the floor and to match the height
of the appliance to that of sur-
rounding units, extend the thread-
ed feet using a screwdriver.
• The drain hose, inlet hose and
mains cable must be laid so that
they are able to move freely within
the plinth area, and so that they
are not kinked or crushed when the
dishwasher is in position.
• The dishwasher must also be
screwed tightly to the work surface
or to the adjoining units. This is essential to ensure the dishwasher
does not tip up.
Free-standing appliances
1
If the dishwasher is installed directly next to a cooker, a heat-insulat-
ing, non-flammable panel (laminated with aluminium foil on the side
next to the cooker) must be fitted flush with the top edge of the work
surface (depth 57.5 cm).
If the appliance is built-in under a
kitchen work surface, the worktop
supplied with the dishwasher can be
removed in the following way:
1. Unscrew the screws from the elbows
at the rear (1).
2. Push the appliance's worktop back-
wards about 1 cm (2).
35