Table of Contents
Advertisement
Installation and Connection Instructions
INSTALLATION AND CONNECTION
INSTRUCTIONS
Installing the Dishwasher
• The dishwasher must be installed on a firm floor and adjusted such
that it is stable and level.
• Using the spanner supplied, extend the threaded feet to compensate
for unevenness in the floor and to adjust the height of the appliance
to suit the surrounding units. The rear feet of the unit are to be
adjusted with a screwdriver from the front of the unit for built-in
and integrated dishwashers.
• The drain hose, inlet hose and mains cable must be laid such that
they are free to move in the rear of the plinth recess, so that they
cannot be kinked or crushed.
• The dishwasher must also be screwed on tightly to the work surface
or to the adjoining units. This is absolutely necessary so that its
stability is guaranteed according to VDE regulations.
• Depending on type, the dishwasher is to be installed as follows:
Dishwashers That Can Be Integrated
(see installation template supplied)
The door of the appliance can be fitted with a wooden/facing panel
3
with the following dimensions:
Width
587mm
Thick-
ness:
Height:
(variable)
Weight:
Downloaded from DishWasher-Manual.com Manuals
32
591 – 594 mm
16 – 24 mm
– Aperture height
dependent on
– Plinth height
– The adjustment so that the unit matches the height of
the adjoining units
The exact height of the adjoining units must be meas-
ured at the place of installation.
max. 8 kg
Advertisement
Table of Contents
