Prism Sound ADA-8 Operation Manual page 3

Prism Sound ADA-8 Multi-channel A/D D/A Converter
WARNING!
TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT
REMOVE THE COVER. NO USER-SERICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
Statements of Conformity
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against interference in a residential
area. This device generates and uses radio frequency energy and, if not installed and used in accordance with the
instructions, may cause interference to radio or TV reception. If this unit does cause interference to radio or TV
reception, please try to correct the interference by one or more of the following measures:
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and the receiving antenna.
c) Plug the equipment into an outlet on a different circuit from the receiver.
d) If necessary, consult your dealer or an experienced radio or TV technician.
CAUTION: Changes or modifications to this equipment not expressly approved by the manufacturer could void the
user's authority to operate this equipment.
THIS DIGITAL APPARATUS MEETS ALL CLASS B LIMITS FOR RADIO NOISE EMISSIONS AS LAID DOWN IN
THE RADIO INTERFERENCE REGULATIONS OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS.
CET APPAREIL NUMÉRIQUE RESPECTE TOUTES LES EXIGIENCES APPLICABLES AUX APPAREILS
NUMÉRIQUES DE CLASSE B SUR LE BROUILLAGE RADIOELECTRIQUE EDICTE PAR LE MINISTERE DES
COMMUNICATIONS DU CANADA.
Prism Media Products Ltd hereby declares that this equipment conforms to the following standards:
EN55103-1, environment category E4
EN55103-2, environment category E4
NOTE: The use of this equipment with non-shielded interface cabling is not recommended by the manufacturer and
may result in non-compliance with one or more of the above directives. All coaxial connections should be made
using a properly screened 75Ω cable with the screen connected to the outer of the connector at both ends. All XLR
connections should use a screened twisted pair cable with the screen connected to pin 1 of the XLR connector at
both ends. In the case of the digital XLR connections this cable should be of 110Ω impedance.
© Prism Media Products Limited, 2002
Operation Manual - Revision 1.00
Page 1.3