Table of Contents
Advertisement
Connecting the
water
Water inlet hose
d Risk of electric shock!
To prevent leaks or water damage, it is essential to
follow the instructions in this chapter!
Attention
Operate the washer dryer with cold drinking water
only. Do not connect to the mixer tap of an
unpressurised hot water apparatus.
If in doubt, have the appliance connected by a
specialist.
Do not use a used inlet hose. Only use the inlet hose
supplied or one which was purchased from an
authorised specialist dealer.
The water inlet hose must not be
- kinked or crushed,
- modified or severed (strength is no longer
guaranteed).
Plastic threads must only be tightened by hand. Do
not remove the strainers from the water supply hose.
Check the mains water pressure:
- The water pressure should be between 1 and
10 bars (when the tap is turned on, at least 8 litres
of water is discharged per minute).
- If the water pressure is higher, install a pressure
reducing valve.
Connect the water supply hose
q to the rear panel of the washer dryer and ...
59
Hide quick links:
Advertisement
Table of Contents
