Washing - Bosch WIA20000EE Installation And Operating Instructions Manual

Washing

Washing
End of the programme
$ Flot antiarrugas (Rinse stop)
Programme change
 Set the programme selector to the desired programme,
e.g. Resistentes/ Algod. (Cottons) 60°C.
 The lavar (wash) (preparado (ready)) indicator light flashes
 Where required, reduce the spin speed or select $ Flot antiarrugas
(Rinse stop)  page 12.
 Load the laundry  page 8.
– Observe the maximum load,
Programme table  page 27.
 Press the % Inicio/Pausa (Start/Pause) button.
– The washing programme starts.
– The lavar (wash) indicator light lights up.
The washing programmes are automatically ended.
 Set the programme selector to Stop (Off).
 Remove the washing from the drum.
 Leave the loading door open in order that the inside of the washing
machine can dry.
 Turn off the water tap.
If the spin function was deactivated at the start of washing,
$ Flot antiarrugas (Rinse stop) (Without final spin = laundry remains in
the last water used for rinsing), the washing programme is stopped after
the last rinse.
In order to drain the rinsing water and, if required, spin the laundry:
 Set the programme selector to centrifugar (spin).
- By pressing the
rpm. The water is emptied and the washing machine spins.
The maximum spin speed depends on the selected washing programme.
i
If you do not wish to spin the laundry:
 Set the programme selector to [ (Empty). The water is emptied but
the washing machine does not spin. The programme has finished
when the terminado (finished) indicator light flashes.
 Set the programme selector to Stop (Off).
 Remove the laundry.
 Leave the loading door open in order that the inside of the washing
machine can dry.
You have selected an incorrect programme by mistake:
 Select the programme again and press
 % Inicio/Pausa (Start/Pause). The new programme starts from the
beginning.
button, the spin speed can be reduced by 200
C 0
13