Bosch WIA20000EE Installation And Operating Instructions Manual page 20

Grey residues on the
washing.
Programme terminated
unexpectedly.
The fabric softener is not
completely flushed in or too
much water remains in the
compartment i
No response from the
indicator lights.
The door cannot be opened.
Emergency release
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Set the programme selector to Stop (Off) and unplug the mains plug from the socket.
– Turn off the tap and call the after-sales service
Soiling caused by ointments, grease or
oil
Amount of detergent too low.
% Inicio/Pausa (Start/Pause) button
selected by mistake.
The fabric softener compartment insert
is not correctly attached or is blocked.
Power failure.
(Rinse stop) selected.
D
The programme is running or the door
is locked for safety reasons.
Power failure.
Set the programme selector to
Stop (Off).
In order to unlock the door mechanically in the event of a power failure, you will
have to:
 set the programme selector to Stop (Off) and unplug the mains plug from
the socket.
 open the base panel and drain out the water  page 16.
 pull the emergency release downwards and open the loading door at the
same time.
– Before opening the loading door, make sure that there is no water or hot
washing water in the appliance.
Under no circumstances open the door with the emergency release while the
drum is still turning.
page 21.

Wash the laundry using the maximum
detergent dosage and the maximum
permissible temperature – see the
care label.
Press the button again to restart the
programme.
Clean the fabric softener compartment
insert and fit it correctly in the
compartment i  page 15.
Programme will continue when power
is restored. If washing is removed
during a power failure, first drain off the
water,  page 16. Check whether:
- the plug is plugged into the socket
correctly
-the circuit breaker (fuse) has tripped.
Call the after-sales service.
Select the programme[ (Empty) and
press % Inicio/Pausa (Start/Pause).
Wait until the End indicator light
flashes.
Unlock the loading door mechanically.
Select any programme. The washing
machine checks whether opening the
loading door is possible. Otherwise,
see Programme termination
 page 14.
20