Table of Contents
Advertisement
Plastic pipe with rubber
sleeve or gully
Connecting the appliance to the electricity supply
Note: Your electrical domestic installation for this
appliance must comply with the local legal provisions and
safety regulations, and should include a residual current
circuit breaker.
Insert the power adapter with the line side into a
1.
suitable socket close to the appliance.
Observe the user manual that is enclosed with the
power adapter.
Insert the mains plug for the appliance's power cord into
2.
the power adapter's load side.
The connection details of the appliance can be found
under Technical data → Page 40 .
Check the power plug is inserted properly.
3.
4.6 Aligning the appliance
In order to reduce noise and vibrations, and to prevent the
appliance from moving, align the appliance correctly.
Use a 17 mm wrench to loosen the lock nuts in a
1.
clockwise direction.
Fix and secure the water
outlet hose with an elbow.
Before using for the first time en-us
To align the appliance, turn the appliance feet. Check
2.
that the appliance is level using a spirit level.
All appliance feet must stand firmly on the ground.
Use a 17 mm wrench to tighten the lock nuts against
3.
the housing until they are hand-tight.
In doing so, hold the appliance foot tight and do not
adjust its height.
5 Before using for the first time
Before using for the first time
Prepare the appliance for use.
Before using for the first time
5.1 Starting an empty washing cycle
Your appliance was inspected thoroughly before leaving
the factory. To remove any residual water, run the first
wash cycle without any laundry.
Press .
1.
The switch-on process takes a few seconds.
Select the Drum Clean program or the drum cleaning
2.
program in the Home Connect® app.
Close the door.
3.
Pull out the detergent drawer.
4.
11
Advertisement
Table of Contents
