Table of Contents
Advertisement
spEciFicaTiONs
compatible
Battery pack
130239010
130240011
ABP-1815
ABP-1813
ABP1801
ABP1802
ABP1801G
ABP1802G
BPL-1815
BPL-1820
BPL-18202PK
OpERaTiON
appLicaTiONs
You may use this product for the following purposes:
Charging compatible Ryobi 18 Volt battery packs.
■
BaTTERy pROTEcTiON FEaTUREs
Ryobi One+ 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life.
If the tool stops during use, release the trigger to reset
and resume operation. If the tool still does not work, the
battery needs to be recharged.
cHaRGiNG THE BaTTERy pacK
Use only Ryobi One+ 18 V battery pack with this
charger:
Battery packs for this tool are shipped in a low charge
condition to prevent possible problems. Therefore, you
should charge them until the green LED on the front of
the charger stays on.
cHaRGiNG a BaTTERy pacK
If the radio charger does not charge the battery pack
under normal circumstances, return both the battery
pack and charger to your nearest Authorized Service
Center for electrical check.
Charge the battery pack only with the charger
■
provided.
Voltage
charger input
240V, 50Hz
18V
AC only
English
chemistry
Ni-cd
Li-ion
Make sure the power supply is normal household
■
voltage, 240V, 50Hz, AC only.
Make sure the latches on each side of the battery
■
pack snap into place and the battery pack is secured
in the charger before beginning operation.
Connect the charger to the power supply.
■
Place the battery pack in the charger aligning
■
raised rib on the battery pack with the groove in the
charger.
Press down on the battery pack to be sure contacts
■
on the battery pack engage properly with contacts in
the charger.
NOTE: After charging is complete, the green LED will
remain on until the battery pack is removed from the
charger or charger is disconnected from the power
supply.
The battery pack will become slightly warm to the
■
touch while charging. This is normal and does not
indicate a problem.
Do not place the radio charger and battery pack
■
in an area of extreme heat or cold. They will work
best at normal room temperature.
NOTE: The charger and battery pack should be
placed in a location where the temperature is
more than 10°c but less than 38°c.
When batteries become fully charged, unplug the
■
charger from the power supply and remove the
battery pack.
To remove the battery pack from the charger,
■
depress the latches on each side of the battery pack.
4
Battery
No. of cell
capacity
per Battery
1.5 Ah
1.5 Ah
1.5 Ah
1.3 Ah
1.7 Ah
1.7 Ah
1.7 Ah
1.7 Ah
1.4 Ah
2.4 Ah
2.4 Ah
15
15
15
15
15
15
15
15
5
10
10
Advertisement
Table of Contents
