Table of Contents
Advertisement
1
5
Green and Yellow
1
3 amp fuse
2
Brown
3
Cord clamp
4
Blue
5
Should the plug need to be replaced for
any reason, the wires in the mains lead are
coloured in accordance with the following
code:
Green and yellow
Blue
Brown
1. Connect the green and yellow (earth)
wire to the terminal in the plug which is
marked with the letter 'E' or the earth
symbol
, or coloured green and yel-
low.
2. Connect the blue (neutral) wire to the
terminal in the plug which is marked
with the letter 'N' or coloured black.
3. Connect the brown (live) wire to the ter-
minal in the plug which is marked with
the letter 'L' or coloured red.
There must be no cut or stray strands of
wire present. The cord clamp must be cor-
rectly attached on the outer sheath.
Warning! Make sure that the cut off
plug is disposed of safely. A cut off
plug put into a 13 amp socket is a
safety hazard. There is a risk of
electrical shock.
2
3
4
- Earth
- Neutral
- Live
Important! The replacement of the
electrical cable must be done by a qualified
electrician or competent person, according
to the current regulations.
REPLACEMENT OF THE CONNECTION
CABLE
To replace the connection cable use only
H05V2V2-F T90 or equivalent type. Make
sure that the cable section is applicable to
the voltage and the working temperature.
The yellow/green earth wire must be ap-
proximately 2 cm longer than the brown (or
black) phase wire.
BUILDING IN
min. 600 mm
min. 150 mm
min. 55 mm
30 mm
480 mm
A) supplied seal
B) supplied brackets
electrolux 7
min. 650 mm
560 mm
A
A
B
Advertisement
Table of Contents
