Pro-Form 790tr Treadmill User Manual page 7

Uk manual
Hide thumbs Also See for 790tr Treadmill:
Table of Contents

Advertisement

2. With the help of a second person, carefully tip the
Upright Base (97) down as shown. (Note: It may be help-
ful to place your foot on one of the Extension Legs [92]
as you tip the Upright Base.) Make sure that the
Extension Legs remain in the Upright Base.
Attach each Extension Leg (92) with two Extension Leg
Bolts (96) and two 1/4" Washers (39) as shown. Next,
thread a Levelling Foot (95) into each side of the Upright
Base (97); do not thread the Levelling Feet fully into
the Upright Base.
Attach the two Base Pads (99) to the Upright Base (97)
in the locations shown with two 1" Tek Screws (135).
With the help of a second person, raise the Upright Base
(97) to the vertical position.
3. Attach the Latch Assembly (82) to the Left Upright (84)
with the two Latch Screws (134). Start both Latch Screws
before tightening either of them. Note: The Latch Screws
may be preattached to the Left Upright.
4. See step 6 and locate the four Upright Bolts (86). Loosen
the Upright Bolts two to three turns.
See drawing 4c. With the help of a second person, hold
the Console Base (101) near the Uprights (80, 84). Look
under the Console Base and locate the wires on the
sides of the Console Base. Make sure that the wires are
not routed through the openings for the Trays (109,
111). Drawing 4a shows the correct route for the wires.
Drawing 4b shows an incorrect route.
See drawing 4c. Cut the plastic ties holding the Wire
Harness (74) and the Pulse Wire (153) in the Uprights
(80, 84). Connect the Wire Harness and the Pulse Wire
to the wires on the sides of the Console Base (101).
Make sure to connect the connectors properly (see
the inset drawings). IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED ON. The
connectors should slide together easily and snap
into place. If the connectors do not slide together easily
and snap into place, turn one connector and try again.
Insert the excess Wire Harness and Pulse Wire up into
the Console Base.
2
99
39
97
92
39
3
134
4a
Correct
4c
111
75
80
7
135
39
92
97
96
95
96
84
82
4b
Incorrect
101
109
81
84
153
74
99
135
96
95
96

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

790 trPetl78132

Table of Contents