Assembly - Pro-Form 7.15q User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Extension Leg Screw (108)–2
WARNING:
cord until the treadmill is completely assembled.
1. Cut the plastic tie off the side of the treadmill.
With the help of a second person, carefully raise the
Uprights (11) until the treadmill is in the position shown.
Insert one of the Extension Legs (34) into the treadmill
as shown. (Note: It may be helpful to tip the Uprights
[11] in the direction shown by the arrow as you insert
the Extension Leg.) Make sure that the Base Pad (40)
is on the indicated side of the Extension Leg. Attach the
Extension Leg with an Extension Leg Screw (108). Be
sure to push on the head of the Extension Leg
Screw whilst tightening it.
Attach the other Extension Leg (34) in the same way.
2. Insert a Handrail (1) into the tube at the upper end of the
right Upright (11). Have a second person hold the
Handrail as you complete step 5.
Handrail Screw (53)–2
Do not plug in the power
and wire cutters
Long Screw/Latch Screw (3)–6
1
2
6
.
11
11
34
40
11
1
108