AEG SANTO Installation Instructions Manual page 5

Two cabinet securing brack-
ets are supplied with the
installation pack. They need
to be assembled onto the
cabinet prior to cabinet
being pushed into the
Kitchen aperture.
To fit these brackets remove
the two screws at the top
left and right hand front corners of the cabinet.
Position the two brackets as shown in the figure and replace the two
securing screws.
Push the appliance into
place. The plug socket
necessary for connection
of the appliance to the
electricity supply should be
positioned, so that the
plug is not placed in the
recess.
To adjust the height pro-
ceed as follows:
Loosen or tighten the two
front feet.
The rear feet are adjusted by turning the screw in the front kick plate
to the left or right.
If necessary, pads are supplied for the
rear feet to make sliding the appliance
in and out of the recess easier. To fit the
pads, press them onto the rear feet.
If required, the dimensions of these
pads can be reduced by breaking them
where marked.
32
Left hand
bracket
1/a
-
+
2
Li89
II52
2/a
Right hand
bracket