Mounting Accessories Included; Wall Unit Mounting - Fig. 7 - Electrolux EFC 9440 User Manual

Installation

Mounting accessories included

1 deflector
1 chimney support
1 reduction flange Ø 125-120 mm
1 support bracket
5 wood-screws 5 x 45 mm
5 wall plugs Ø 8 mm
6 metal screws 2,9 x 6,5
6 metal screws 3 x 9

Wall unit mounting - Fig. 7

Disconnect the hood during electrical connection, by turning
the home mains switch off.
Remove the 2 screws fitted inside the lower part of the hood
at the points in which it is fixed to the suction unit (see
also operation 3).
• Fix each other both parts of the hood (1), make all
connections between the two parts (2) and fix with
8screws (3 - also use the 2 screws previously
removed).
• Mark the wall with a centre line, this will aid
mounting procedure (4), position the template so
that the mid line printed on the template matches
with the center line previously drawn, the lower
side of the template corresponds to the
lower side of the hood once
mounted (5).
• Drill two holes Ø 8mm and fix
the support bracket with two
wall plugs and screws (6).
Hang the hood (7) and
adjust its position (8-9).
• From the inside of the hood
mark one point for final fixing
(10). If necessary remove the
charcoal filter frame.
• Remove the hood (11) and drill
one hole Ø 8mm (12), fit one wall plugs (13).
• Rest the chimney support bracket G against the wall, touching the ceiling. Use the support bracket as a
drilling template and mark 2 holes with a pencil (14), drill the holes insert 2 wall plugs, fix the chimney
support bracket to the wall using two screws (15) (If the hood is to be used in filter version, fix deflector F to
the chimney support bracket G using 4 screws).
• Hang the hood again (16) and fix it with one screw (17).
• Connect an exhaust pipe to the outlet hole of the hood D (18) for direct discharge of fumes to the outside
(Extractor version) or to be connected to the connection ring located on the bottom of the deflector F (Filter
version).
• Make the electrical connections (19).
• Fix the chimney sections and fix them at the top to the chimney support G (20b) using 2 screws (20a), slide
the bottom section of the chimney down until it completely covers the suction unit and slots into the housing
provided on top of the hood.
Fig. 7
11