Mounting Accessories Included; Wall Unit Mounting - Electrolux EFC 6410 User Manual

Installation

Mounting accessories included

1 deflector
1 chimney support
2 grids
2 hooks
4 wood-screws 5 x 45 mm
4 wall plugs Ø 8 mm
2 metal screws 3,5 x 6,5
2 metal screws 3 x 9

Wall unit mounting -

Fig. 8
• Put the template onto the wall
(1) and drill two Ø12mm holes
(2).
• Fit two hooks (3) on the drilled
holes.
• Hang the hood on the hooks and
adjust the position of the hood
using the two screws on the
bottom of the hooks (5).
• Remove the metal filters (4) and
mark two points (6). Remove
the hood and drill two Ø8mm
holes on the marked points.
Fit two Ø8mm wall dowels (7),
Hang again the hood and fix the
hood definitively with two
screws 5X45 (8).
• Fix the chimney support (10)
with two screws 5 x 45 mm (9)
and two wall dowels (11) on the
wall close to the ceiling.
• For exhausting version: Fit
the connection ring (S) on the
top of the hood with two screws
Ø 3,5 x 6,5 mm (12S) then fit
an axhausting pipe long enough
to reach the outside (13S).
For recycling version: Fix
definitively the deflector (13K) on
the top of the hood with two screws Ø
3,5 x 6,5 mm (12K).
• Prepare the electric connection (14) (see
relative chapter).
• Fit the chimney (15) and fix it on the chimney
support with two screws 3,0 x 9 mm (16).
The lower part of the chimney must be slided
down and inserted on the housing on the upper
part of the hood (17).
• Fit the two grids (18) on both sides of the
chimney.
Ø 120 mm
Fig. 8
33