• Do not cover the parts of the appliance
with aluminium foil.
• Do not cover the ventilation space be-
tween the worktop and front of the unit
Before the installation, note down
the serial number (Ser. Nr.) from the
rating plate.The rating plate of the
appliance is on its lower casing.
Made in Switzerland
220-240 V 50/60 Hz
/ Induction 3,6 kW
Warning! You must read these!
Make sure that the appliance is not
damaged because of transportation.
Do not connect a damaged appliance.
If it is necessary, speak to the supplier.
Only an authorised service technician
can install, connect or repair this appli-
ance. Use only original spare parts.
Only use built-in appliances after you
assemble the appliance into correct
built-in units and work surfaces that
align to the standards.
Do not change the specifications or
modify this product. Risk of injury and
damage to the appliance.
Fully obey the laws, ordinances, direc-
tives and standards in force in the
country where you use the appliance
(safety regulations, recycling regula-
tions, electrical safety rules etc.)!
Keep the minimum distances to other
appliances and units!
Install anti-shock protection, for exam-
ple install the drawers only with a pro-
tective floor directly below the appli-
Protect the cut surfaces of the worktop
against moisture with a correct sealant!
Seal the appliance to the work top with
no space left with a correct sealant!
Protect the bottom of the appliance
from steam and moisture, e.g. from a
dishwasher or oven!
941 560 812 / 00
Warning! If there is a crack on the
surface, disconnect power supply
to prevent the electric shock.
Do not install the appliance adjacent to
doors and below windows! If not, hot
cookware can be hit off the hob when
you open doors or windows.
Warning! Risk of injury from electrical
current. Carefully obey the instructions
for electrical connections.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
• Install correctly to give anti-shock protec-
• Loose and incorrect plug and socket
connections can make the terminal be-
come too hot.
• A qualified electrician must install the
clamping connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains cable of type
H05BB-F Tmax 90°C (or higher) for a sin-
• Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C;
or higher). Speak your local Service Force
The appliance must have the electrical in-
stallation which lets you disconnect the ap-
pliance from the mains at all poles with a
contact opening width of minimum 3 mm.
You must have correct isolation devices:
line protecting cut-outs, fuses (screw type
fuses removed from the holder), earth leak-
age trips and contactors.
• You can use the fixing clamps supplied
with the appliance to install it in a work-
top with a minimum thickness of 42 mm.
With thinner worktops you must use a
spacer (not supplied with the appliance).
TO ATTACH THE SEAL.
• Clean the worktop in the area of the cut
• Bond the seal stripe supplied on the low-
er edge of the appliance along the outer