To Install The Seat - Ford Windstar Owner's Manual

To install the seat:

1. Remove (if necessary) tub covers from the floor to expose the seat
mounts.
• To remove the tub cover(s), use a
screwdriver to pry the tub cover
(where indicated) upward and
out of the floor tub.
• To install the tub cover(s), first
insert the tabs located on the
opposite side of the pry location
into the slots of the floor tub then
press down on the other side of
the cover until it snaps into place
securely. (Additional tub covers
can be purchased as an accessory
from your dealer.)
2. Position the seat in the vehicle.
The 3rd row bench seat can be
placed in the 2nd row position.
3. Align seat front hooks to front tub pins, lower back of seat into the
rear tubs until both release controls latch into place. Be sure that the
seat is locked in place both front and back.
4. Make sure the safety belt is not twisted, then insert the seat belt
tongue into detachable anchor (if equipped) until you hear a "click" and
feel the latch engage.
2003 Windstar (win)
Owners Guide (post-2002-fmt)
USA English (fus)
Seating and Safety Restraints
97