Advertisement
Installation of the PX-G1 (continued)
6. Following safe rigging practices, attach rated safety cabling (not included) from the material lift to the eyebolts
(See Figure 12).
WARNING! The center of gravity of the array is located below the hole on the material lift
forks. Never exceed the load limits or the maximum load height that is specified by the
material lift manufacturer. Always place the material lift on a flat, stable surface and use all
stabilizer hardware. Take extra caution when used in windy, outdoor applications that could
cause the array to become unstable. Consult the material lift user manual for proper use and safety guidelines.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 8/2007
Part Number LIT000059 Rev A
Figure 12: Attaching Safety Cable through Eyebolts
U.S.A. and Canada only. For customer orders,
contact the Customer Service department at
800/392-3497 Fax: 800/955-6831
Europe, Africa and Middle East only. For customer orders,
contact the Customer Service department at
49 9421-706 0 Fax: 49 9421-706 265
For warranty information, contact the Service Repair department at:
616/695-6831 or 800/685-2606
For technical assistance, contact Technical Support at:
Specifications subject to change without notice.
866/78AUDIO
Advertisement
