Advertisement
Installation of the PX-G1 (continued)
2. Set the array bracket on top of the loudspeakers, and
align the holes on the array bracket with the suspension
points on the loudspeaker. Attach the washers, lock
washers, eyebolts (not included) and M10 button head
screws to the threaded suspension points on the
loudspeakers, using a hex key (not included). Torque all
fasteners down so that the lock washers are fully
compressed. Note final orientation of eyebolts. For
permanent installations, use a thread locker (not
included) on the button head screws and eyebolts (See
Figures 5 and 6).
WARNING! Electro-Voice strongly
recommends that M10 forged
shoulder eyebolts that are compliant
with DIN580 standards are used as
redundant safety points for the array (See Figure 5 for
recommended locations). Eyebolts are not included.
3. Remove the M10 flat head screws that are located at
the bottom of the enclosure in the rear, and install the
rear hinge plates (See Figure 7). There are different
configurations for the rear hinges depending on how
many enclosures are used (See Figure 8).
Button Head Screw, Lock
Washer, and Flat Washer
(One for Each Plate)
Figure 7: Assembling the Rear Hinge Plates
(3 x PX2122, 30° Splay Shown)
Flat Head Screws must be
removed before Plates are
Installed
Eyebolt, Lock
Washer, and
Flat Washer
(x2)
Figure 6: Assembling the Array Bracket to an
Array of Phoenix Loudspeakers
(3 x PX2122, 30° Splay Shown)
2 Enclosures
(Use both Outer Plates)
Figure 8: Possible Hinge Plate Configurations
for 2 or 3 Enclosures
Button Head Screw,
Lock Washer, and
Flat Washer (x5)
3 Enclosures
(Use All Plates)
Advertisement
