Advertisement
PX-D2
The Electro-Voice® PX-D2 accessory consists of a pair of dolly plates with assembled casters for use with the Phoenix
PX2181 Loudspeaker. The dolly plates double as skid plates for extra protection of the PX2181's back panel.
1. Remove (16) 5/16" bolts from rear of the PX2181 enclosure.
2. Align holes in the PX-D2 with the holes on the PX2181 enclosure, and tighten the (16) 5/16" bolts into the dolly
boards (see Figure 3).
CAUTION! If the dolly boards are removed, replace the (16) 5/16" bolts into the rear of the
enclosure. If the bolts are not replaced, the speaker will have air leaks resulting in undesirable
performance.
Remove Existing
Screws, Install
Dolly Plates, then
Re-attach Screws
(16 Places)
Figure 3: Assembling the PX-D2 to a Phoenix PX2181 Loudspeaker
Fully Installed
Dolly Plates
Advertisement
