Installation - Electrolux EWF 106110 A User Manual

Problem
The appliance fills with
water and drain imme-
diately.
The washing results
are not satisfactory.
After the check, activate the appliance. The programme continues from the point of inter-
ruption.
If the problem occurs again, contact the service centre.
Service
Refer to the information supplied with this
appliance for guarantee condition and point
of contact. The information to give to the
service is on the rating plate.

INSTALLATION

Unpacking
1. Use the gloves. With a scissor cut the
straps and with a cutter remove the ex-
ternal film.
Do not to discard the plastic cover (A).
1
Possible cause
The end of the drain hose is
too low.
The detergent you used was
not sufficient or correct.
You did not remove the stub-
born stains before you wash
the laundry.
Incorrect temperature was set.
Too much laundry load.
A
2
Possible solution
Make sure that the drain hose is in the
correct position. Refer to 'Installation'.
Increase the detergent quantity or use a
different one.
Use special products to remove the
stubborn stains.
Make sure that you set the correct tem-
perature.
Decrease the laundry load.
We recommend that you write the
information here:
Model
Product number
Serial number
(S.N.)
2. Remove the polystyrene packaging
materials.
electrolux 15
..................
914.............
..................